多网口主机桥接设置带宽异常求助

zsy

机器有enp1s0、enp3s0双网口，enp1s0接路由，开启ovs，enp3s0加入同一ovs网桥实现桥接，连接电脑网卡，nas和电脑都是2.5G网口，飞牛防火墙完全放开，ufw放行了所需端口。

几个版本前smb还能跑满2.5G，就最近1到2次更新后，smb会走路由器（校园网）转一圈，导致限速到50Mbitps左右，从网页下载文件（连接enp3s0的电脑访问enp1s0的ip）能跑到800Mbitps左右，没转路由器但跑不满速度。
这种情况是飞牛调整了网络设置或者smb的设置吗？还是说电脑的smb设置不对？
这种蛋疼的网络结构玩不下去了？有没有大佬能救救QAQ

当前网络结构：（省略冗余的docker网络）

zsy@zbfn:~$ ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host noprefixroute 
       valid_lft forever preferred_lft forever
2: enp1s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 xdpgeneric/id:28 qdisc pfifo_fast master ovs-system state UP group default qlen 1000
    link/ether 00:e0:4c:77:74:25 brd ff:ff:ff:ff:ff:ff
3: enp3s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 xdpgeneric/id:28 qdisc pfifo_fast master ovs-system state UP group default qlen 1000
    link/ether 00:e0:4c:77:74:26 brd ff:ff:ff:ff:ff:ff
    inet6 fe80::60be:440f:88e6:1959/64 scope link noprefixroute 
       valid_lft forever preferred_lft forever
4: wlo1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN group default qlen 1000
    link/ether 46:d6:fc:f2:4c:0e brd ff:ff:ff:ff:ff:ff permaddr 70:08:10:d3:ab:d5
    altname wlp0s20f3
5: ovs-system: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
    link/ether 5e:be:46:01:ee:5b brd ff:ff:ff:ff:ff:ff
6: enp1s0-ovs: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN group default qlen 1000
    link/ether 00:e0:4c:77:74:25 brd ff:ff:ff:ff:ff:ff
    inet 59.66.195.**/24 brd 59.66.195.255 scope global dynamic noprefixroute enp1s0-ovs
       valid_lft 3361sec preferred_lft 3361sec
    inet6 2402:f000:4:1008:809:ffff:fffb:5aa/128 scope global dynamic noprefixroute 
       valid_lft 129101sec preferred_lft 85901sec
    inet6 fe80::236a:2d66:70f1:4373/64 scope link noprefixroute 
       valid_lft forever preferred_lft forever
7: tailscale0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1280 qdisc pfifo_fast state UNKNOWN group default qlen 500
    link/none 
    inet 100.100.35.33/32 scope global tailscale0
       valid_lft forever preferred_lft forever
    inet6 fd7a:115c:a1e0::4932:2321/128 scope global 
       valid_lft forever preferred_lft forever
    inet6 fe80::f8ab:70d8:7b25:3541/64 scope link stable-privacy 
       valid_lft forever preferred_lft forever
8: virbr0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000
    link/ether 52:54:00:08:84:73 brd ff:ff:ff:ff:ff:ff
    inet 192.168.122.1/24 brd 192.168.122.255 scope global virbr0
       valid_lft forever preferred_lft forever

zsy@zbfn:~$ sudo ovs-vsctl show
[sudo] password for zsy: 
19d20c10-43b1-4509-82d6-bcc1bf2cd08e
    Bridge enp1s0-ovs
        Port enp1s0
            Interface enp1s0
        Port enp3s0
            Interface enp3s0
        Port enp1s0-ovs
            Interface enp1s0-ovs
                type: internal
    ovs_version: "3.1.0"
zsy@zbfn:~$ cat /proc/sys/net/ipv6/conf/all/forwarding
1
zsy@zbfn:~$ cat /proc/sys/net/ipv4/ip_forward
1